Installation Instructions

Here is how to assemble your Light it Up kit:

  1. Size up your leads, cut with some spare so you can fine tune
  2. Strip off (ideally w/ 18 gauge stripper) 1-2 diameters of insulation
  3. Heat fiber near but outside of flame to form hemispherical tails (for improved light transmission.
  4. Insert leads into ocular piece (this is a tight friction fit, best to brace piece on table and pinch lead in both hands to insert it)
  5. Place shrink tube over leads for organization. You can shrink it now or after finishing assembly.
  6. Try fit-up on your scope. Adjust leads as necessary.
  7. Apply and cut mounting tape (if you want to use it). Be aware VHB tape is very tough and may leave residue.
  8. Mount the leads into the clip-on Send It housing.
  9. Go shooting and Light it Up!

A short slideshow showing assembly can be found at my Instagram (linked below).